Project 24 - Battledown Flyover #4 (full span)

Here is the full span, having joined the three parts together.

It was at this point I came across an article that cited the length as being 145 feet, not 150 feet that I had estimated. If the article is right then in 4mm scale the span is 20 mm too long! Too late now, this lot took about 39 hours to print and I am not repeating the exercise. I will plough on to print the other side, then the floor and then the three girders that go across the top.

To Part 5.

To Part 1.

Read about the SLA (stereolithography) resin 3D printer I use here.