Third Time Lucky? - Battledown Flyover #2

Here are the parts that make up one side of the bridge, except the three girders at the top span both sides.

So far there have been no breaks or warp using the Anycubic Water Washable ABS Like V3.0 resin. I am particularly pleased that the thin handrails have held their form (1mm diameter) although time will tell if they droop due to gravity like the other resin fabrication did.

Another nice aspect is that the print time is about half that of the other resins I used before. 

The next photo is to show off the rivet detail achievable with this technology. Each rivet is 0.5mm diameter.

The assembled side ready for painting. It is just over half a metre long.

To Part 1.